The 1" wide rubber strip can stay on, if you are going from a 3-tower per side factory rack to a 3-tower per side Gamiviti rack. better yet, run a M8 x 1.25mm tap down there to clean those threads up, otherwise it's possible to bugger this one up when you install the rack. when you get the rack off, squirt some lube in there, then run a bolt down with nothing on it. So there is going to be a bunch of dirt in there. On LX models, they didn't put a bolt in the forward location of your center towers. chance you got one with that cheap set of screwdrivers and/or drill attachments you bought. Either way, you won't use those bolts again, and you may not ever use that T-30 tip again.
TESLA MODEL 3 ROOF RACK INSTALL T SLOT BOLT DRIVER
You will need to find a T-30 Torx driver for LX models, 12mm for Land Cruisers. On the 80 series, if you're running 45 degree towers you actually don't have to remove anything, however it makes using your new rack a little easier if you get that old one out of the way, regardless of the fact that it will clear it. You only have to remove the long raised rails on the sides, you don't have to remove the thinner rails that are secured to the roof in the center. Once removed, you can put smaller bolts back into those same holes, using some silicone (see below) and rubber sealing washers. Squirt penetrating oil onto the screw heads for several days prior to removal. This is a well-documented process and you should be able to easily find info on this specific to your vehicle, here are a few tips we have found to be most relevant and worth adding here. Prior to installing your rack you must first remove your old one. If you find you need more help or have additional questions, use our Contact Us form to get in touch. Below are some installation tips for roof racks.
0 kommentar(er)
